Then take the flat brace that comes with the dipstick, and bend with a 90 bend the one in the kits I use is Stainless so the chrome won't crack or anything.
Then put two (or three) seals on top of the stop. And adjust bracket to put a little tension down on the tube.
Bolt in place.
Intially trim end of dipstick until its short enough to seat in top of tube.
Note the new dipstick and a bend to stay in the tube and a cup on the top to keep the oil from venting oil all over the motor.
When you have the length bend the end of the dipstick with a nice curve. Then slide it in as shown.
Fill motor to the proper amount of oil as per manual, and check dipstick and mark your oil level.