Goin MPI Progress

These are the bushings to make our 12-1 Cam sensors for the upcoming Goin MPI.

We are developing an MPI fuel injection for the Opel CIH 4 cylinder that will fit under the hood of the Opel GT and thus most Opels.

Custom 3-D Printed Intake Manifolds?

www.opelgt.com

The FULL Goin MPI kit is now finalized.

The price for the full kit has DROPPED to $2299 and you get :

The Fuel side :

Custom Intake CNCd' out of Aluminum
Throttle Body (60mm)
Throttle cable bracket
IAC Step motor ( Built in to Throttle body )
TPS Sensor ( Built in to Throttle body )
Intake mounted MAP Sensor
Thermostat Sensor ( Mod of your thermostat housing reqd)
Bosch 3 Wire wide band Sensor
Four Fuel Injectors ( 20lb / 3Bar / 14.3 OHM )
Fuel Rail
AN Fittings - (2) AN6 and (1) AN8

The Ignition side :

Distributor ( Setup for Wasted spark with a 12-1 shutter)
Wasted Spark Coil
ICM ( Ignition Control Module)

ECU:

kptronics.gr custom made ECU for our application
Complete wiring harness
Harness terminated at the ECU and at the sensors
( Roughly 4-6 wires to hook up )
Base Opel CIH tune prebaked into the computer (Optional performance tune available )
Bluetooth connectivity to the ECU

All you should need is a fuel system to the rail ( Relay for Fuel pump in the computer ) and spark plug wires, and a modification to your thermostat housing

( Although thermostat housings are also something I am looking at making. )

We hope to making 10 of the complete kits..

Intake Kit with fuel rail and sensors and connectors, but without the ECU/Distributor will be $1790

We will have 10 high port and 10 low port intakes on this first run. That way IF we make a second run I have an idea of how many of each I need.

1-804-503-0249 if interested.